Sensorsoft ST6105J User Manual download pdf (Page 13)

Sensorsoft Remote Watchman Express/Client User Manual

Cancel Button: Click this button to abort any changes and close the window.

Apply Button: Click this button to activate/save your changes without closing the window.

Please note that it is very important to click the Apply button after all desired changes.

Important Tip: Always click the Apply or OK button to save all changes on the form and

prevent an unnecessary technical support incident.

Pager Alerts Tab

Pager alerts are useful if you need to inform people that are not near the monitored location, about

potential problems. Pager alerts can be sent to a variety of paging devices such as dedicated

numeric and alphanumeric pagers, e-mail pagers and cell phones with text messaging. This

software uses industry standard SMS-TAP or DTMF to deliver messages to your paging device.

Sending page messages requires an AT compatible modem to be installed/attached to the

computer that is running this software. If you require pager alerts then it is here that you set the

modem type and port, pager type and alert specifications for each type of alert event.

The pager specific settings below have to be completed individually for each alert event.

Remember to Apply your changes after completing the information for each alert event.

Important Note: This software must be able to open the COM port where your modem is

installed and therefore is not compatible with TAPI devices. If you have RAS (Remote Access

Service) enabled on your modem port, please refer to your Windows documentation or support to

turn it off.

If you are new to paging or the Remote Watchman line of products, you may wish to read

Appendix A – Pager Tutorial and Appendix B – Modem DIP switch settings before continuing.

Figure 4

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 41 42

No comments

Sensorsoft ST6105J User Manual Page 13