Sensorsoft ST6105C User Manual download pdf (Page 43)

Sensorsoft Alert User Manual

In the command lines above, ttyS4 is the name used to access serial port 4. The relay can be

connected to any serial port on the back of the Alert appliance. As an example, if the relay was

connected on serial port 8, use ttyS8 in the command line.

5. For each command line alert that you would like to enable, check the corresponding Enable checkbox.

6. Click on the Save Changes button.

7. It is highly recommended that you test all of your commands to ensure that they are properly setup.

You can test each command by clicking on its Test Command Line button.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 88 89

No comments

Sensorsoft ST6105C User Manual Page 43